INCORRECT ACCESS CODES
If three incorrect access codes are entered within five minutes a tamper fault
will be generated.
1. SETTING FULL SYSTEM
Enter the allocated four digit user code, the exit/entry warning sounder will
emit a soft continuous tone. Leave by the appointed exit route. The system
will set after the predetermined exit time and the exit/entry warning sounder
will silence. When the system has set only the green mains light will be lit.
If a fault is present when the user code is entered, the sounder will pulse and
the L.E.D. display wil indicate the zone or zones in fault. Clear the faults and
start again.
2.
SETTING PART SYSTEM
Enter the allocated four digit user code. Press the * key followed by the 0
key, the exit/entry warning sounder will emit a low continuous tone. The pre
set part guard zone indicators will pulse (omitted). Leave by the appointed
exit route.
If a fault is present when the user code is entered, the sounder will pulse and
the L.E.D. display will indicate the zone or zones in fault. Clear faults and
start again.
3.
SETTING WITH INDIVIDUAL ZONES OMITTED
Enter the allocated four digit user code, the exit/entry warning sounder will
emit a steady tone. The individual zones may now be omitted, proceed as
follows:-
Press the * key followed by the zone number key. The zone L.E.D. will pulse
indicating zone has been omitted.
The FX zone is omitted by key 6 and the IX zone is omitted by key 5.
Any zones that have been pre programmed for high security may not be
omitted by the above procedures. An error tone will be given.
Leave by the appointed exit route.
