RabbitCore RCM2200, Getting Started Manual, Page: 13 / 34

Getting Started Manual Hardware Setup 2–5
2.3.1 Attach Module to
Prototyping Board
Turn the RabbitCore RCM2200 module so that the
Ethernet connector end of the module extends off
the Prototyping Board, as shown in Figure 2–3
below. Align the module headers J4 and J5 into
sockets J1 and J2 on the Prototyping Board.
Although you can install a single module into either
the Master or Slave position, all of the development
board features (switches, LEDs, serial port drivers,
etc.) are connected to the Master position. We rec-
ommend you install a single module in the Master
position.
Figure 2–3:
Installing the RCM2200 module on the Prototyping Board.
Figure 2–4: The RCM2200 module installed and seated on the Prototyping Board.