RabbitCore RCM2100, Getting Started Manual

Page: 19 / 47

Getting Started 15
2.3.4 Connect Power
When all other connections have been made, you can connect power to the RCM2100 Pro-
totyping Board.
Hook the connector from the wall transformer to header J5 on the Prototyping Board as
shown in Figure 7 below. The connector may be attached either way as long as it is not
offset to one side.
Figure 7. Power Supply Connections to Prototyping Board
Plug in the wall transformer. The power LED on the Prototyping Board should light up.
The RCM2100 and the Prototyping Board are now ready to be used.
NOTE: A
RESET
button is provided on the Prototyping Board to allow hardware reset
without disconnecting power.
To power down the Prototyping Board, unplug the power connector from J5. You should
disconnect power before making any circuit adjustments in the prototyping area, changing
any connections to the board, or removing the RCM2100 module from the Prototyping
Board.