Safety
Instructions
Operating
Instructions
T
roubleshooting
T
ips
C
ustomer
S
ervice
01
02
29
30
TROUBLESHOOTING
Before calling for repair or replacement, or technical support, please review
the list below. The problem may not be due to unit malfunction. If your
problem is still unresolved after reviewing this guide, please call Rabbit Air
Technical Support Team.
The unit does
not operate.
Speed will not
change.
Air Quality
Indicator does
not change
when cigarette
smoke is in the
air or when the
air is highly
polluted.
Speed is
too slow.
Symptom
Check
Solution
Are the lights on display
panel off?
Press the power and
mode button.
Is the unit plugged in?
Plug the unit into a
110/120V outlet.
Is the electricity cut off?
Operate the unit after
electricity is resumed.
Does it continually indicate
'Very Clean'?
Raise the sensitivity.
(Page 22)
Is the room dark?
You can’t select the
speed when the silent
mode is on.
Has the auto mode been
selected?
You can't select the
speed when the auto
mode is set.
Is the Particle Sensor clean?
Clean the lens.
(Page 24)
Does it continually indicate
'Not Clean'?
Lower the sensitivity.
(Page 22)
Have you cleaned or replaced
the filters yet?
Check the cleaning and
replacement schedule.
Do not attempt to install this product if you do not understand the instructions. Contact a qualified
contractor to install the mounting brackets and call 1-888-866-8862 if you have any questions. You
risk the possibility of damaging the Air Purifier, damaging other property and personal injury if the
mounting brackets are not installed properly. Check to make sure there are no missing or defective
parts. Do not attempt to assemble the mounting brackets if there are missing or defective parts.
Contact Rabbit Air and replacement parts will be shipped to you immediately. Rabbit Air is not liable
for damage or injury caused by incorrect mounting, incorrect assembly or incorrect usage.
ㆍ
After installing the wall mount, make sure it is firmly in place before putting the air purifier on it.
ㆍ
The biggest concern mounting on the wall is wiring in the wall. It
’
s hard to be sure, but be careful
not to drill or screw into any wiring.
Correct installation is extremely essential, and falls outside the scope of responsibility of Rabbit Air.
Please consult a qualified contractor and/or specialist supplier to install the mounting brackets.
Maximum weight of air purifier SPA-780A / SPA-700A: 9.1 kg/20lbs.
Disclaimer for installing wall mounted object
<Installation>
Use the optional wall-mount kit to install the air purifier.
▶
Wall-Mountable (Optional)
Place the unit at some certain distance away from the
ceiling and the other walls as shown on the picture at
the right.
▶
Be careful not to drop the front panel or filter case when
replacing the filters.
▶
Do not pull on the power cord.
Drive in the screws of the hanger very tightly so that the unit will not fall off.
Summary of Contents for SPA-780A
Page 18: ......
