INSTRUCTIONS
X17™
XFU 3-WAY FIELD-ADJUSTABLE
FLOODLIGHT INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
X17 XFU 60/50/30W Knuckle
KNUCKLE MOUNT
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
WARNING: Do not use an electric generator to test LED fixtures.
WARNING: Min 75°C SUPPLY CONDUCTORS.
1. Secure the fixture to a 1/2” NPS hole in the junction box or
landscape post as shown in
Fig. 1.
Seal arm thread using
Teflon® tape or silicone sealant.
2. Make appropriate wire connections per NEC in an approved
enclosure
(not included)
see
Fig. 7.
3. The
Knuckle Arm
allows 180° of vertical aiming adjustment
depending on the mounting position as shown in
Fig. 2.
Fig: 1
Fig: 2
Knuckle Arm
Pole
TRUNNION MOUNT
To adjust the angle of the
Fixture
using the
Trunnion
(Fig. 4):
1. Loosen the
Pivot Bolts
and
Angle Locking Screws
.
2. Make appropriate wire connections per NEC in an approved
enclosure
(not included)
see
Fig. 7.
3. Adjust fixture to desired angle.
4. Tighten
Pivot Bolts
and
Angle Locking Screw.
SLIPFITTER MOUNT
1. Place the
Slipfitter
over the
Tenon
and secure the
Fixture
with
the
Locking Bolts
(
4
)
on the side of the
Slipfitter
as shown in
Fig. 3.
2. Make appropriate wire connections per NEC in an approved
enclosure (
not included)
see
Fig. 7.
3. Loosen the
Locking Bolts (
4
)
and swivel
Fixture
to desired angle.
4. Tighten the
Locking Bolts
(
4
).
Fig: 3
Fig: 4
Pivot Bolt
Angle Locking Screw
X17 XFU 60/50/30W Trunnion
X17 XFU 60/50/30W Slipfitter
Fixture
Slipfitter Mount
Locking Bolt (
4
)
Wire
Tennon
To ensure weatherproof seal, apply weatherproof silicone sealant
around the edge of the junction box
(not supplied)
. This is especially
important with an uneven wall surface.
