background image

20W LED WALLPACK INSTALLATION INSTRUCTIONS 

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE

.

RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper 
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE 
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT.

 

WARNING:  

Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.

Thank you for buying 

RAB LED lighting. 

Comments?  Call us at 

888-RAB-1000, or email: 

[email protected]

JUNCTION BOX MOUNT FOR 

CONDUIT

For use on applications where conduit wiring is needed.

1.  Loosen and remove (4)

 Lens Screws

.  Remove 

Door

.  

2.  Loosen and remove (2) 

Housing Screws

. Remove 

Housing

 from 

Back Box

.  Keep 

Housing Gasket

 intact 

for re-assembly.

3. Secure 

Back Box

 to the mounting surface using 

hardware appropriate for that mounting surface.

4. Wire the fi xture using UL listed wire connectors 

according to NEC and local codes.  Apply sealant to all 
unused conduit entry points.

5. Place 

Gasket

 between 

Back Box

 and 

Housing

.  

Re-mount 

Housing

 to 

Back Box

. Check 

Housing

 

Gasket

 seal all around the 

Back Box

6. Re-mount 

Door

 to 

Housing

. Tighten (4) 

Lens Screws. 

Check door gasket (not shown) seal.

7.  Fixture is UL Listed for down and up lighting and may 

be mounted in either position. Fixture may not melt 
heavy snow accumulation in an uplight position.

CAUTION:  For proper weatherproof function all gaskets 
must be seated properly and all screws inserted and 
tightened fi rmly.

Lens 
Screws

Junction Box 

Surface Mount 

Back Box

Housing 
Gasket

Housing

Door

Housing 
Screws

SURFACE MOUNT FOR 

RECESSED JUNCTION BOX

For use with recessed junction box and wiring.

1. Mount 

Surface Plate

 to fi xture with

 

(4)

 Surface Plate 

Screws

.  There are two screws from the front and two 

screws from the back. Make sure 

Housing Gasket

 

makes complete seal all the way around.

2.  Use supplied crossbar. Mount 

Crossbar

 to recessed 

junction box with (2) screws.

3. Place 

Junction Box

 

Gasket

 on back of the fi xture. 

Gasket should create seal against mounting surface.

4. Wire fi xture to supply wires in recessed junction box 

according to wiring section.

5.  Use 1/4 x 20 stainless steel 

Mounting Screw

 to attach 

fi xture to Crossbar. Tighten 

Mounting Screw

.

6.  Cover screw with 

Cap, 

provided.

7.  Fixture is UL Listed for down and up lighting and may 

be mounted in either position. Fixture may not melt 
heavy snow accumulation in an uplight position.

CAUTION:  For proper weatherproof function all gaskets 
must be seated properly and all screws inserted and 
tightened fi rmly.

Crossbar

Junction 
Box Gasket

Mounting 
Screw

Cap

Recessed
Junction Box
(not provided)

Surface 
Plate

Housing 
Gasket

(4) Surface 
Plate Screws

Reviews: