INSTRUCTIONS
STL200H/L, STL200HB/L INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
SETTINGS
(cont’d)
Fig. 3
Fig. 4
Fig. 2
HOW DOES THE LED DETECTION
INDICATOR WORK?
LED Detection
Indicator
Masking the Lens
100˚
Top View 30’
Side View 30’
10’
Detection Pattern
CHOOSING A LOCATION
Note:
These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation or maintenance.
Will Stealth detect animals?
Stealth may detect large animals.
Having animals trigger the sensor can give property a “lived-in”
look. However, you can limit animal detection by turning down the
sensitivity knob and/or by using the plastic lens mask supplied on
the lower part of the lens as shown in
Fig 2
.
How are the Time, Sensitivity and Photocell adjusted? Fig 3
Time:
Sets the time that lights will remain on after the detection
zone is vacated from approximately 5 seconds to 12 minutes.
Factory Setting: 5–8 minutes
Sensitivity:
Increases or decreases the responsiveness and range of
the sensor (Adjusts from 30% to 100%) Factory Setting: 100%
Photocell:
Located behind the lens. For night only operation,
turn the knob all the way clockwise to (to the moon symbol).
For 24 hour operation turn the knob all the way counterclockwise
(sun & moon). Adjust clockwise to have the sensor come on later at
dusk, counter-clockwise to have it come on earlier. Factory Setting:
Night Only.
The red LED above the lens shows the logic state of the sensor. If
the sensor is set for night only operation, the LED will go on for
daytime detections without turning on the lights
(Fig 4)
. At night,
the LED will be on all the time, except during detections (at which
time the controlled lights will go on). At night, the LED serves as a
deterrent indicating a security device in operation.
Choose a location from which the sensor can “see” all the paths of
movement. The sensor may be wall or ceiling mounted.
As distance from the sensor increases, it will take more movement
to be detected. For instance, at 10 feet, a half step will be enough,
while at 40 feet several steps will be necessary.
How large an area does Stealth200 detect?
The Stealth200
provides a 200
°
detection pattern. To reduce the angle of coverage
on either or both sides, use the plastic blinders provided
(Fig 2)
.
The blinders can also be cut sideways and used to reduce low or
high detection.
The sensor maybe swiveled in any direction to to cover the area
desired. Always keep the sensor level to ensure full coverage.
To reduce coverage, aim the sensor towards the ground.
Stealth STL200 comes with a standard “Double Look Down” Lens.
This lens has one “Look Out” zone and two “Look Down” zones, for
excellent detection both at long and close range.
