INSTRUCTIONS
SHARK® INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
Surface Mounting
Bracket (4)
ANGLE SURFACE MOUNTING
Angle Surface Mounting Brackets Fig. 8
(
ANGSHARK8-G2
ordered separately
)
1. Use appropriate mounting hardware
(not supplied)
to secure the
ANGSHARK8-G2 Bracket (4)
to
Mounting Surface
.
2. Recomended
ANGSHARK8-G2 Bracket
distance center to center is 17 3/4” and end to end is 82”.
3. Secure
Surface Mounting Brackets (4)
to
ANGSHARK8-G2 Bracket (4)
with
Screws
provided.
4. Snap
Housing
on
Surface Mounting Brackets (2
) as shown in
Fig. 9
.
Fig: 8
Fig: 9
Corner Bracket (4)
Screws
Housing
0-10V DIMMABLE WIRING
Universal voltage driver permits operation at 120V thru 277V, 50
or 60 Hz. Units ordered with (/480V) suffix are 480V, 50Hz or 60Hz.
For 0-10V Dimming, follow the wiring directions in
Fig. 10.
1. Connect the black fixture lead to the LINE supply lead.
2. Connect the white fixture lead to the COMMON supply lead.
3. Connect the GROUND wire from fixture to supply ground.
Do NOT connect the GROUND of the dimming fixture to the
output.
4. Connect the purple fixture lead to the (V+) DIM lead.
5. Connect the gray fixture lead to the (V-) DIM lead.
6. Cap the yellow fixture lead, if present. Do NOT connect.
Fig: 10
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer to
wiring directions.
2. Is the fixture grounded properly?
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough to touch.
Do not clean or maintain while fixture is energized.
1. Lens should be washed in a solution of warm water and
any mild, non abrasive household detergent, rinsed with
clean water and wiped dry.
WARNING: Polycarbonate is affected by cleaning agents
or other liquids containing partial solvents such as
low molecular weight aldehydes and ethers, ketones,
esters, aromatic hydrocarbons and perchlorinated
hydrocarbons. In addition, chemical attack ranging from
partial to complete destruction of polycarbonate occurs
in contact with alkalines, alkali salts, amines and high
zone concentrations. Please go to rablighting.com for a
detailed list of damaging chemicals.
2. Do not open fixture to clean the LED. Do not touch the LED.
