INSTRUCTIONS
SHARK® INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
Latch
Surface Mouting
Bracket
Conduit Plug (8)
Mounting Surface
Lens and Tray
Assembly
SHARK - 8FT
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
firmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.
SURFACE MOUNTING
The fixture is suitable for outdoor applications in wet locations
either ceiling or wall mounted.
1. Use appropriate mounting screws
(not supplied)
to secure the
Surface Mounting Brackets (4 included) to Mounting Surface.
WARNING: Mount Surface Mouting Brackets (4)
farther away
from each other and symmetrical about the center as shown
in
Fig. 1. Surface Mounting Brackets(4)
must be aligned with
each other to secure
Housing.
2. Electrical splices can be easily made using
6ft Cord
attached to
one end of the
Housing.
In order to use an alternate
Conduit
Plug
entry point, follow steps below.
3. Unlatch the
Lens and Tray Assembly
from
Housing. Tether
Cables
will prevent
Lens and Tray Assembly
from falling down
as shown in
Fig. 1.
4. Feed supply wires through one of the
Conduit Plugs (8)
to
make electrical splices. Cord-grips (4) are provided and can be
used based on the application.
5. Secure
Lens and Tray Assembly
to
Housing
by
Latch
. Be careful
not to pinch wires. Check that the
Gasket
is fully seated.
6. Use appropriate UL approved wire connectors as required by
code to complete connection with supply wires. Be careful not
to pinch wires.
WARNING: To prevent wiring damage or abrasion, do not
expose wiring to edges of sharp objects.
7. Snap
Housing
on
Surface Mounting Brackets (4)
as shown in
Fig. 2.
Ensure that the
Housing
is secure to
Surface Mouting
Brackets.
8. Use Silicone or teflon tape on all
Conduit Plugs (8)
and on the
threads of all conduit entry points. If outdoor surface is irregular,
use caulk to seal any gaps around the
Housing.
Fig: 1
Fig: 2
82
"
(2084mm)
17.8"
(453mm)
Surface Mounting Bracket (4)
6ft Cord
Housing
Lens and Tray
Assembly
Tether
Cable
Latch
Gasket
