YBLED 40W-60W INSTALLATION INSTRUCTIONS
®
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for
safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING:
Make certain power is OFF before installing or maintaining fixture.
LOCATION
Select a location on a structurally sound, flat wall or pole. Fixture should be located on wall or pole at least 18” below any overhang
or other structural detail. Fixture must not be recessed.
YBLED Button PC
YBLED 3 pin PCT
YBLED 5 pin PCT
YBLED LC
MOUNTING TO WALL
1. Secure the fixture to a sturdy wall. Using the mounting
arm as a guide, mark the 3 mounting holes. Drill 3/16”
pilot holes and use provided
Lag Bolts (3)
to mount to
wooden surface or use appropriate mounting hardware
(not supplied) suitable for the mounting surface.
2. Install the 2 bottom
Lag Bolts
first. Screw in the
Lag
Bolts
so that there is about 3/8” of space under the
head.
3. Place the fixture on these 2 bottom
Lag Bolts
. Install
the top
Lag Bolt
then tighten the other 2 bolts.
4. Loosen screw and remove the
Arm Cover.
5. Knock out the appropriate
Conduit Knockout
on the
Arm Cover
to route input conduit. Use appropriate
conduit connectors as required by code. Connect wires
as shown in wiring diagram. Push all wires back into the
Housing Arm
. Be careful not to pinch wires.
6. Secure the
Arm Cover
and tighten screw.
7. Apply weatherproof silicone sealant around the edge
of the
Housing Arm
and the wall. This is especially
important with an uneven wall surface.
YARM24 MOUNTING
1. Secure the
Interlocking Mounting Clamps
around the
YARM24
using the provided truss screws, locknuts and
hex-nuts.
2. Mount the
YARM24
to a sturdy wall. Using the
YARM24
mounting plate as a guide, mark the 4 mounting holes.
Drill 3/16” pilot holes and use provided
Lag Bolts (4)
to
mount to wooden surface or use appropriate mounting
hardware (not supplied) suitable for the mounting
surface.
3. Remove the
Arm Cover
by loosening the screw. Remove
the
Clamp
by loosening the 2 screws on the
Clamp
.
4. Knock out the arm-entry knockout on the
Arm Cover
.
Secure the
YARM24
and the
Clamp
in the
Housing Arm
and tighten the clamp screws.
5. Knot wires in
YARM24
for strain relief and feed wires
from the
YARM24
into the
Housing Arm
. Make the
necessary wiring connections in the
Housing Arm
.
Connect wires as shown in wiring diagram. Push all wires
back into the
Housing Arm
. Be careful not to pinch
wires.
6. Secure
Arm Cover
and tighten the screw.
Lag Bolts (3)
Arm Cover
Conduit Knockout
Housing Arm
Lag Bolts (4)
YARM24
Arm Cover
Clamp
Housing Arm
Interlocking Mounting Clamps
