![background image](http://html1.mh-extra.com/html/rab-lighting/wp4-series/wp4-series_installation-instructions_3120813001.webp)
WP4 INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED. Observe all caution and warning labels.
WARNING:
Make certain power is OFF before installing or maintaining fixture.
Thank you for buying RAB lighting
fixtures. Our aim is to design the
best quality products to get the job
done right. We’d like to hear your
comments. Call the Marketing
Department at 888-RAB-1000, or
email: [email protected]
LOCATION
1. Secure the Wallpack to a solid surface. Do not recess
any part of this fixture.
2. Mount over a junction box or feed with conduit on
each side, top or bottom. Using lag bolts to secure
fixture to the mounting surface is recommended.
3. To ensure weatherproof seal, use the supplied
mounting gasket and seal all mounting plugs, conduit
entrances and along all sides of the fixture with
weatherproof silicone sealant.
Backbox
WIRING
All QT units are factory wired for 277V except those
factory ordered with a 120V Photocell (/PC). If other
voltages are required, remove reflector and rewire for the
appropriate voltage.
1. Open door and remove the reflector by loosening the
(4) Reflector Screws.
2. Connect the desired tap from the ballast to the (+)
LINE supply lead.
3. Connect the white fixture lead to the (-) COMMON
supply lead.
4. Connect the bare copper Ground wire from fixture to
supply ground.
5. Replace the reflector. Tighten screws. Install the
lamp and close the door.
Reflector
Screws