WP3 INSTALLATION INSTRUCTIONS
TROUBLESHOOTING
1. Is the proper lamp is installed? Check the wattage
and ANSI code on the fi xture label against markings
on the lamp. Refer to Replacement Lamp table
above for verifi cation.
2. Make sure the lamp is not defective. Try a lamp
known to be in operating condition.
3. Check that the line voltage at fi xture is correct. Refer
to wiring directions.
4. Is there voltage at the lamp socket? If there is no
voltage, check all connections.
5. Is the fi xture grounded properly?
6. Is the photocell functioning properly (if used)?
ACCESSORIES AND
REPLACEMENT PARTS
Chrome Wire Guard:
GDWP3W
Door Frame & Glass:
GLWP3F
(bronze)
GLWP3FW
(white)
Factory Installed Photocell:
“/PC” (120V)
“/PC2”
(277V)
“/PCS”
(Swivel
120V)
Quartz Restrike
“/QR” HID only
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
WP3-IN-0609
REPLACEMENT LAMPS AND
BALLASTS
Lamp
ANSI
Ballast
Wattage Catalog# Code
Catalog#
High Pressure Sodium
250 LHPS250
S50
BHPSH250QT
Metal Halide
200 Pulse St LMH200PSQ M136
BMHH200PSQ
250 Pulse St LMH250PSQ M138
BMHH250PSQ
Compact Fluorescent
Base Type
120 LCFL120
2G8-1
BCLF120
RAB fi xture designs are protected under U.S. and International
Intellectual Property laws. Patent Pending.
-*()5
'*9563&
-*/&
#-"$,
$0..0/
8)*5&
(306/%
(306/%
CLEANING & MAINTENANCE
CAUTION: Be sure fi xture temperature is cool
enough to touch. Do not clean or maintain while
fi xture is energized.
1. Clean glass lens with non-abrasive glass cleaning
solution.
2. As lamps age, light output diminishes. Mass
relamping at regular intervals ensures full light output
at the highest effi ciency.
LAMP INSTALLATION
CAUTION: Prior to installing, check that the lamp is
the correct ANSI type and wattage. Observe lamp
manufacturer’s recommendations on lamp operation,
ballast type and burning positions.
1. Disconnect power. Make sure fi xture and lamp are
cool enough to touch.
2. Loosen
Door Screws (2)
from the door frame. A
small rubber O-ring will retain screws. Open door.
3. Fully insert lamp into socket.
4. Before closing door, make sure gasket is properly
seated all around the backbox of the wallpack. Close
the door. Tighten
Door Screws
.
Door
Screws
WIRING SCHEMATIC
