TALLPACK
Thank you for buying RAB lighting fi xtures. Our aim is to design the best quality products so you can get the job
done right. We’d like to hear your comments. Call us at 888-RAB-1000, attention Marketing Department.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
RAB Tallpack fi xtures must be wired in accordance
with the National Electrical Code and applicable
local codes. Proper grounding is required for safety.
Tallpack fi xtures are for outdoor use and should
not be used in areas with limited ventilation or high
ambient temperatures. Installation should be done
by a qualifi ed electrician.
USE SUPPLY WIRE RATED FOR 90°.
WARNING: RISK OF FIRE. MOST DWELLINGS BUILT BEFORE
1985 HAVE SUPPLY WIRE RATED FOR 60°. CONSULT AN ELECTRICIAN BEFORE INSTALLING.
Warning: Make certain power is OFF before installing or maintaining fi xture.
LOCATION
Fixtures should not be recessed and is for wall mount only.
Fixture must be positioned with lamp in vertical position
with lampholder base up.
MOUNTING
1. Loosen 2 screws from both sides of the front refractor.
2. Remove front refractor.
3. Remove refractor by loosening screws just enough to
allow refl ector to slide upward until keyhole in refl ector
releases screws.
Standard Box Mounting:
1. Remove center ½" Plug to route wires.
2. For 3½" or 4" round box or 4" square box, knockout
2 or 4 slotted openings in rear housing for screw
attachment to box (screws not provided).
3. Use gasket supplied. It is also advised to use
weatherproof silicone sealant to prevent entry of
moisture into fi xture.
Odd-sized Box Mounting:
1. Remove center ½" Plug to route wires.
2. Knockout 2 mounting holes in housing.
3. Mount with 2 lag screws (not provided) which will
penetrate at least ¾" of wood or similar solid surface.
4. Use weatherproof silicone sealant when mounting
fi xture to outlet box and mounting surface to prevent
entry of moisture into fi xture.
Bottom Conduit Mounting: See Back
Installation Instructions
Mounting
Knockout
Slotted
Knockout
½" Threaded
Opening
Refl ector
Fluorescent
Socket and
ballast compartment
