RAB Lighting FALCOR 80W, Installation Instructions Manual

Page: 1 / 82

FALCOR INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
TM
CAUTION
SILICONE ALL PLUGS AND UNUSED CONDUIT ENTRIES FOR WEATHER PROOF SEALING.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside
.
FOR AISLE FIXTURE
1. Loosen the
screw
connecting
Housing Head
to Junction
box.
2. Rotate the
Housing Head
all the way as shown in Fig.1.
3. Tighten the screw .
FIXTURE MOUNTING
Mount Housing to sturdy ceiling structure as follows:
FOR HOOK MOUNTING:
1. V Hooks (2) are provided for chain mounting. Secure
V Hooks
through
Bracket Hole
at back of
Housing
as in
Fig. 2.
2. Connect to two (2) equal lengths of chain (by others) and/
or appropriate hardware (by others) suitable for mounting
surface, to suspend
Housing
from
V Hooks.
3. Fixture mounting height and spacing should be determined
by application requirements. Use chain suitable to support
four (4) times the weight of the fixture (42 lbs).
4.
Brackets (2)
should be positioned near end of Housing as
shown in Fig.2. Secure Housing to ceiling mounting surface
and adjust
Brackets
evenly to ensure
Housing
is stabilized.
5. Unlatch and open the Wiring Box and slide Cord in
Wiring Box
. Use approved wiring connectors and wire to
local NEC codes.
FOR PENDANT/ SURFACE MOUNTING:
1. Choose pendant length (3/4” NPS Pendant Stem not
supplied) and feed
Cord
through pendant stems. If longer
cord is required, replace the Cord with the appropriate length
wires. For wet locations wrap threads on pendant stems with
teflon tape and silicone gel. Screw the pendant stem to the
Wiring Box
. Tighten set screw.
2. Alternatively, mount Wiring Box to ceiling by drilling out drill
locations. Use the appropriate mounting hardware for the
mounting surface. Be sure gasket is properly seated.
3. Unlatch and open the
Wiring Box
and slide
Cord
in
Wiring Box . Use approved wiring connectors and wire to
local NEC codes.
V Hook
Wiring Box
Housing
Pendant
Fig: 1
Screw
Head in Aisle
Position
Junction
Box
FALCOR
80W
FALCOR
160W & 230W
FALCOR AISLE
80W
FALCOR AISLE
160W & 230W
Bracket
Bracket Hole
Fig: 2
Fig: 3