21 / 32
User Manual
Rev. 1.0 - 20/06/08
PJ500C-LCD, PJ700C-LCD & PJ1000light
6.2 Rear Panel
Figure 6.2
[1] R.F. TEST
Output with level -60 dB lower than output power level,
suitable for modulation monitoring. Not suitable for spectrum
analysis.
[2] GSM SLOT-IN
Reserved for future implementations
[3] GSM ANT
Reserved for future implementations
[4] AIR FLOW
Air grille.
[5] 10MHz
Reserved for future implementations
[6] MAINS
Terminal board for 115-230 V 50-60 Hz mains power supply.
[7] FUSE 1
Mains power supply fuse [chap. 5.1 - Table 1].
[8] R.F. INPUT
“N”-type RF input connector.
[9] R.F. OUTPUT
RF output connector, N-type for
PJ500C-LCD
and
PJ700C-
LCD
7/16” for
PJ1000-LIGHT
.
[10] INTERLOCK OUT
Interlock output BNC connector: when the transmitter goes
into stand-by mode, the (normally floating) central connector
is connected to ground.
[11] SERVICE
DB9 connector for factory setting
[18] INTERLOCK IN
Interlock input BNC connector: when central conductor is
connected to ground, the transmitter is placed into forced
standby mode.
[13] MODEM
Reserved for future implementations
[14] FWD EXT. AGC
Trimmer to set output power limitation according to FWD
fold input (chap.6.3.2 - Pin [2]).
[15] RFL EXT. AGC
Trimmer to set output power limitation according to RFL fold
input (chap.6.3.2 - Pin [10]).
[16] REMOTE
Telemetry DB15 connector.
[17] RS232
Reserved for future implementations
[18] SERVICE VOLTAGE SEL.
115-230V mains voltage selector.
[19] SERVICE FUSE
Service fuse [chap. 5.1 - Table 1].
[20] FUSE 2
Mains power supply fuse [chap. 5.1 - Table 1].
