●
Flip on the Power switch, on the rear of the Prism printer.
●
Wait until the Prism printer is fully initialized.
●
Power on your 5100.
●
When your 5100 reaches a certain point in the boot up process, it should show a screen like this:
| |
|Found 1 Hard Disk |
|Found RQ Prism Plus |
| [Self Test 32] |
●
If that screen has the "Prism Plus" line, then your printer is ready.
●
If you miss that screen, you can go to your "Setup" Menu, and enter "Printer Setup" to verify
that your printer is ready.
●
From the 5100's main menu, enter the "Utilities" Menu. Go to "Loader Utilities", "Loader
Utilities", "Extended Diags".
○
After the Loader calibrates from your entry into Extended Diags, place a disc on the pick
finger.
○
Enter "Set Printer", and align your loader robot to your printer.
○
You may have to adjust the thumbscrew on the printer plate, to make larger adjustments.
●
At this point, your printer should be completely ready to use.
