R. Beck Maschinenbau EXAKT ELG/DC, Operating Manual, Page: 29 / 37

29
BA_BM_EXAKT-ELG-DC_EN_37-23.docx
10.3.3.3 Single mode (incremental)
Figure 14: Single mode (incremental)
•
Single operation on incremental measurement
positions the material stop relatively. This
means that the measurement always refers to
the previously executed positioning.
•
Select this mode with the button
→
The symbol appears in the display.
•
To position to incremental measurement, navi-
gate the cursor to the X window below using
one of the two navigation keys

/

.
•
Press the ENTER

button repeatedly until ei-
ther or appears.
•
The symbol signals the running direction to the positive and the symbol to the negative.
Please note: However, the actual running direction of the stop must be determined on site, as it depends
on whether the roller conveyor is on the left or right side of the processing machine.
•
To enter the target value, navigate the cursor to the “ Target ” window using one of the two navigation keys

/

. Then enter the target value via the numeric keypad and confirm the entry with ENTER

.
•
If the position is entered incorrectly, you can delete the value with the “ Clear ” button (see

Figure 11).
•
The positioning of the material stop starts as soon as the green START button is pressed.
•
When the START button is pressed again, the stop moves again by the same distance.
•
The positioning can be cancelled with the red STOP button.
•
If required, a number of pieces can be entered in the window .
•
The stop can be referenced with the “ F2 ” key (see

10.2)
Acute danger of crushing at the material stop! As soon as the START key is pressed, the sliding
carriage starts moving automatically! Keep persons and body parts out of the danger areas. In
case of danger, press the emergency stop immediately!
10.3.3.4 Program mode
Figure 15: Program mode
•
The programme mode enables the operator to
combine several individual blocks into one
programme and to process them.
•
Select this mode with the button
→
The symbol appears in the display.
•
First enter a program number (1 - 50) by
navigating with the cursor to the window next
to the symbol with one of the two
navigation keys

/

.
•
Enter the desired number via the keypad.
•
Confirm with ENTER

.
•
After entering the program number, the symbol with two numbers appears to the right (see example 1/6
in

Figure 15). The left number represents the current block number for the target position of the stop and
the right number represents the number of program blocks in the selected program.
•
If this field is activated with the cursor via the navigation keys

/

, the existing program blocks can be scrolled
forwards and backwards with the “ F1 ” and “ F3 ” keys.
•
To change the target value within a program, navigate the cursor to the target value window and change the
value using the numeric keyboard. Then confirm with
ENTER

.
Target
Target