23
BA_BM_EXAKT-ELG-DC_EN_37-23.docx
9.1.2
Aligning and levelling the roller & measuring conveyor
To align the roller & measuring conveyor optimally to the processing machine, proceed as follows:
•
Align the roller & measuring conveyor both in line and level with the existing processing machine (saw, drill
etc.). If the roller conveyor is supplied in several segments, always start with the roller conveyor part on
which the operating switches are mounted (right or left of the machine, depending on the configuration).
•
For levelling and height adjustment, an open-end spanner SW 24 (for EXAKT STANDARD) resp. SW 30 (for
basic roller conveyor EXAKT ES and EXAKT MES) is required.
Figure 4: Levelling feet
•
Adjust the feet so that the roller & measuring conveyor stands se-
curely and horizontally on all levelling feet. Level the roller & meas-
uring conveyor exactly with a spirit level and adjust it to the level of
the processing machine. To do this, loosen the lock nut (
K
) and adjust
the height with the set screw (
S
). Then tighten the lock nuts (
K
) again.
•
Then firmly join the processing machine with the roller & measuring
conveyor.
•
Boreholes (
A
) see section
9.1.3
Joining roller & measuring conveyor segments together
In the case of a roller & measuring conveyor delivered in sections, the roller & measuring conveyor segments
must be joined together.
•
Before mounting, first remove the cover plates that are already pre-assembled on delivery in order to ac-
cess the corresponding mounting holes at the joints of the roller track segments from above.
•
First align roller & measuring conveyor segment 1 correctly
→
Then place the roller & measuring conveyor
segment 2 against the already aligned roller & measuring conveyor segment 1 and align it exactly to it.
Figure 5: Connecting flat bar and segments
•
Afterwards the delivered roller & measuring conveyor seg-
ments must be connected to each other on the front and
rear side with the two connecting lugs (
L
) by screwing them
together (see
•
Screw the vertically mounted guide flat bars (
F
) of the roller
& measuring conveyor tightly together with the screwed-on
connecting bracket (
V
), see
•
When attaching the connecting bracket (
V
), make sure that
the flat bars are exactly flush with each other
→
The air gap
between the flat bars should be as small as possible.
9.2
Anchoring in the ground
When all parts are assembled and aligned to the machine, anchor the roller & measuring conveyor to the floor
via the four holes (
A
) in the foot plates with heavy duty dowels (see
9.3
Setting up the swivel column with positioning control
In the state of delivery, the P40 positioning control is already installed in the switch box of the supplied swivel
column and electrically connected to the roller conveyor via cable.
•
Select the installation location so that the control unit is optimally aligned for your work area.
•
Important:
Anchor the swivel column in the ground using the holes in the base plate with heavy-duty dowels.
K
S
A
L
V
F
F