Test/Link Button
LED
Note: Always install
so that the
TEST/LINK BUTTON
is accessible
Mode 1:
Linking to a transmiter.
Hold the ”Link” button for approximately 3 seconds or un l the LED starts flashing (medium rate),
then press the desired transmiter buon to be linked.
Confirma on of linking will be indicated with 3 flashes.
Mode 2:
Set OFF level
(LED dimming stop/off level)
Note 1:
Mode 2 se ng is only equired when using the unit to dim an LED load, this allows you
to stop and switch off the LED dimming at a level higher than 0.
Note 2:
Before changing Mode 2, first ensure that you have set the unit to be a dimmer (as per
Mode 3 explana on)
Note 3:
Before changing Mode 2, first link the unit to a trransmier (as per Mode 1 explanana on)
Ac on:
1: Set the light level that you require the LED to switch o ffat, using the linked trransmier.
2: Hold the ”Link” buton for approximately 5 seconds or un l the LED flashes at a fast rate, then
release the buton.
3: To clear this level and reset it to “0”, repeat step 2.
Mode 3:
Choose between Relay (ON/OFF) and DIM mode.
1: Hold the buton for approximately 8 seconds or unn l the LED flashes at slow rate, then
release the buton. The unit will now change mode from ON/OFF to DIM mode or visa-versa.
2: Repeat step 1 to revert to the alternate mode. (DIM changes to ON/OFF & ON/OFF changes to
DIM)
Mode 4:
Clear all se ngs and reset to default mode.
Default (ON/OFF)
Hold the button for approximately 10 seconds or un l the LED is permantly on, then release the
button. All se ng will now be closed and returned to default.
Please note:
If the mode is changed between DIM and ON/OFF, the device will need to be deleted
and then re-added to the app or online interface.
QS-R-DOPTO
DIMMER
RECEIVER
LED/
HALOGEN LEADING
EDGE
10W
x20
SWITCH
1A
200W/1A Multi Function Receiver
QS-R-DOPTO
200W/1A Multi Function Receiver
QS-R-DOPTO
www.qwikswitch.co.za
