© Copyright Qvis® All documentation rights reserved.
25
4.4.4.5 Pattern
Pattern function can memory PTZ operation and camera focus zoom in and zoom out.
From the start position, dome begins auto movement repeatedly.
This series IP dome supports maximum 5 patterns and one pattern can max support 400 commands.
Move the cursor to PATTERN and click confirm button.
PATTERN NO
：
Here is to set pattern number. The value ranges from 1 to 5. Please click left/right key to
configure.
PROGRAM START: Here is to memorize pattern starting point. An icon OK pops up in screen to prompt you
system begins memory pattern.
PROGRAM STOP
：
Here is to set pattern stop point. After all the movement, move the cursor to
PROGRAM STOP and then click confirm button. Now you have set one pattern. System pops up an icon
OK to prompt you system has memories one pattern.
RUN
：
Here is to activate pattern. Input pattern number, move the cursor to RUN and click confirm button,
system begins running pattern.
STOP: Here is to stop current pattern. Input pattern number, move the cursor to STOP and click confirm
button. System stops current pattern.
BACK: Go back to previous menu.
EXIT: Log out system menu
.
Note:
The dwell time between two orders should be less than one minute, otherwise system will set to default
value as one minute.
After click PROGRAM STOP, do not click CALL button before icon “●” disappears completely.
Any manual operation during the pattern procedure will terminate current dome pattern operation.
PATTERN NO: 001
PROGRAM START
PROGRAM STOP
RUN
STOP
BACK
EXIT
