QVI Cobra DRS-300, User Manual

Page: 36 / 100

Unpacking Procedure
Note: Before unpacking Cobra 3D, be sure to review the Support Surface
Requirements topic for information about setting Cobra 3D on a stable working
surface.
To unpack and set up Cobra 3D, follow the steps below.
Note: This procedure assumes that if you are supplying your own computer, the
computer is already set up and ready to be connected to Cobra.
1. Use a fork lift or pallet jack to move the pallet containing Cobra 3D and
accessories to the installation site.
The metal bands that bind the shipment are under considerable tension and
may recoil unpredictably when cut.
2. Use a pair of diagonal cutters to cut and remove the two metal bands that
bind the shipment (see Figure 2-15).
3. Remove the shrink wrap and heavy plastic from around the system boxes.
Installation and Setup 2-15
Installation
and
Setup
Figure 2-15. Removing the Packing Material