Model: MLGY16006
Made in China
Save instructions for
future reference
4
5
6
7
8
9
10
11
12
14
Tubes angle in at
the top and can-
not be assembled
upside down
13
15
16
Step by Step Assembly Instructions:
1
Orient the 3 top curls
B C D
as shown. Slide the post of
the lower curl
D
through the tube of the middle curl
C
.
2
Slide the tube of the upper curl
B
over the post of the
lower curl
D
.
3
Screw the finial
A
on to the threaded top of the lower curl
post
D
.
4
Rotate & align the 3 top curls
B C D
over the tubes of the
small support ring
H
. Note that the curls on the small support
ring
H
are on the bottom.
5
Insert the threaded end of the shorter support pole
E
through
a tube on the small support ring
H
and screw it into the
threaded hole on the end of the lower curl post
D
.
6
Insert the threaded end of another shorter support pole
E
through a tube on the small support ring
H
and screw it into
the threaded hole on the end of the middle curl post
C
.
7
Insert the threaded end of the last shorter support pole
E
through a tube on the small support ring
H
and screw it into
the threaded hole on the end of the middle curl post
B
.
8
Align the medium support ring
I
under the three shorter
support poles
E
. Note that the curls on the medium support
ring
I
are on the bottom.
9
Insert the threaded end of the longer support pole
F
through
a tube on the medium support ring
I
and screw it into the
threaded hole on the end of one shorter support pole
E
.
10
Insert the threaded end of another longer support
pole
F
through a tube on the medium support ring
I
and
screw it into the threaded hole on the end of another shorter
support pole
E
.
11
Insert the threaded end of the last longer support pole
F
through a tube on the medium support ring
I
and screw it
into the threaded hole on the end of the last shorter support
pole
E
.
12
Align the large support ring
J
under the three longer support
poles
F
. Note that the curls on the large support ring
J
are on the bottom. Slide the tubes over the ends of the three
longer support poles
F
.
13
Insert a screw
O
at each connection point. Finger tighten the
screws to hold the large support ring
J
in place.
14
Insert the curved legs
G
one at a time into the tubes on the
bottom of the large support ring
J
. Use one screw
O
at each
connection point. Finger tighten the screws to hold the curved
legs in place.
15
Insert the posts on the bottom of the leg support ring
K
into
the tubes on the curved legs
G
. It may be necessary to loosen
the screws that hold the curved legs to align the tubes.
16
Double check all connections and adjust and tighten as
necessary for a tight fit. Use the hex wrench
P
to firmly
tighten the 6 hex screws taking care not to over tighten.
17
The three baskets
L M N
are removable in use. The ring
on the bottom of each basket fits inside the ring of the
corresponding support ring on the stand.
1
2
3
E
F
A
B
C
D
H
I
J
K
L
M
N
O
P
E
E
F
F
G
G
G
Tubes angle in at
the top and can-
not be assembled
upside down
13
13
O
O
O
14
14
14
14
15
15
17
17
17
Curl 3 Tier Basket
ASSEMBLY INSTRUCTIONS