12/19
Quuppa Q17 Installation Guide and Safety Information
Quuppa Oy, Keilaranta 1, 02150 Espoo, Finland
© 2018 Quuppa Oy
5.2.
Connect to power supply
Option 1: Use Power over Ethernet (PoE)
Quuppa Q17 supports the use of standard IEEE 802.3at PoE (Power over Ethernet) components, e.g.
PoE switch or power injector, as its power source. Only use standard certified PoE devices. When using
PoE, a separate DC power supply is not required.
Option 2: Use separate 5V DC Micro USB
If you are not using PoE components, connect Quuppa Q17 to 5V power supply with Micro USB. Only
use compatible power supplies. Contact Quuppa in case of any uncertainty regarding compatible power
supplies.
When the power supply is connected Quuppa Q17 automatically switches on. The red indicator light
flashes multiple times, after which the red indicator light turns constantly on until the Quuppa Q17 is
connected to the Quuppa Positioning Engine.
5.3.
Connect to network
Connect Quuppa Q17 to a network with Ethernet CAT5 UTP cable using the RJ-45 Ethernet socket. For
your safety and to prevent any damage to Quuppa Q17, only connect Quuppa Q17 to standard certified
network components.
The red indicator light is flashing slowly when Quuppa Q17 is properly connected to the network but not
activated by the Quuppa Positioning Engine software.
Follow the Quuppa tutorials to configure your Quuppa Q17. The blue indicator light is flashing or
constantly lit when Quuppa Q17 is activated by the Quuppa Positioning Engine software.
5.4.
Reset to factory settings
To reset to factory settings, press the reset button while connected to power supply and keep it pressed
for approximately three seconds. The red indicator light flashes for a moment, then stays on for a
moment and then turns off. After that the Quuppa Q17 switches on normally with the default factory
settings.
