5.2 The quLD Module
current while you are working in another module (see gure
). By clicking the PiP
button once more you can disable this mode again.
Figure 4: The rst tab of the quLD module with enabled picture in picture mode.
5.2.2 Settings
The settings tab is shown in gure
. Here you can set various options which should not
be changed by an unauthorized user, such as maximum and minimum of the laser diode
set values. Additionaly you can change the rate of the proportional and integral part of
the temperature feedback loop.
After setting those values you can either save them to the EEProm of the quLD hardware
or discard them by loading the saved values from there.
Warning: Do not change the preset maximum and minimum
values unless you are absolutely sure this is necessary and safe
to do. Wrong parameters can lead to a complete failure of the
quED.
quCR Manual Version 3.2 Page 10
