In the case
‘
No good
’
, Please draw the disengagement pin out which
corresponding to the broken place.
When use DIE-F35/Y35 Die set to punch A4size sheets, the right first
disengagement pin should be pull out to avoid broken.
⑤
Push down and turn Margin Width adjuster to set margin width, there
are 2/4/6/8mm four classes (See chart below).
⑥
Before punching in batches, use one test paper to check the side margin
and margin width.
·
Punch in order
①
Align the document sheets and sliding into the paper entrance against
paper stop, please don
’
t insert punching sheets once too much otherwise
the edge of punched holes will be coarse.
②
Please operate under machine parameter permission.
③
Push down punching handle to punch.
After p
④
unching finished, take out the punched paper.
·
Special size paper punching
①
Paper longer than A4 should be punched twice. This should be achieved
by adjusting Paper stop, Disengagement pins and using the slot at the side of
paper entrance.
②
Paper shorter than A4, the key point is to avoid paper edge broken, to
pull out some disengagement pins can avoid this problem but should use
suitable binding accessories.
⑥
文件使用
"pdfFactory Pro"
试用版本创建
www.fineprint.cn
