Remove the panel from the transmitter and
then install one 23A/12V battery (included).
To prevent damage to transmitter, remove
the battery if not use for long periods of
time (Fig. 15).
A.
I, II, III, IV, V
and
VI
buttons:
These six buttons are used to set the
fan speed as follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
B.
button:
This button turns the fan off.
C.
Reverse button:
This button is to control fan direction.
This button must be pressed while fan
is running (suggested speed IV).
7. INSTALLING THE WALL CONTROL
8. OPERATING
YOUR
TRANSMITTER
REMEMBER
- Turn off the power!
NOTE
- Control must be installed within 30 feet of fan.
1.
Remove the existing wall plate and
switch from the wall junction box.
2.
If your outlet box has a ground wire
(green or bare copper) connect the wall
control's ground wire to it; otherwise
connect the wall control's ground wire
directly to one of the screws from the
outlet box.
3.
(Fig. 14) Carefully tuck the wire
connections inside the junction box.
Secure the wall control with the two
screws provided. Attach the wall plate
over the wall control and secure with the
two screws provided.
Fig. 14
D.
Light button:
This button is to control optional light.
Switch the "D" and "ON" dip switch
on the front of transmitter to decide the
light in "ON/OFF" or "Dimmable"
condition.
E. ON - OFF
Slide button:
Power
switch.
(Fig. 16)
F.
Signal light
(Fig. 16)
NOTE:
If multiple fans are installed on
the same circuit, each fan must have it’s
own switch leg. Each fan and wall control
pair must have its own wire from the control
to the fan(the wire from the control to the
fan can NOT be shared). There can NOT
be a jumper wire running from fan to fan.
The receiver provides the following
protective function:
1.
Lock position:
The DC motor has a
built-in safety against obstruction during
operation. The motor will be locked
operation and disconnect power after 30
seconds of interruption. Please remove
obstacles before re-set.
2.
Over 80W protection:
When the
receiver detects motor power consumption
which is greater than 80W, the receiver
power will be stopped and operation will
immediately discontinue. Turn the receiver
power on after 5 seconds.
Fig. 15
Fig. 16
Power
switch
Signal
light
Summary of Contents for The Fury 65
Page 11: ......