1.
Make sure the wiring is safely inside the
outlet box as instructed in Step 5 - Electrical
Connections. To install the canopy, remove
the 1 of 2 screws from the bottom of the
mounting bracket and loosening the other
one a half turn from the screw head. Slide
the canopy up to mounting bracket and
place the key hole on the canopy over the
screw on the mounting bracket, turn canopy
until it locks in place at the narrow section
of the key holes. Secure tightening the two
set screws. (Fig. 9)
2.
Blade Assembly & Installation (Fig. 10)
Using the supplied blade arm screws, attach
the blades to the blade arms. In some cases
the fiber washer is permanently fixed to the
screw head. Ensure all screws are used for
each blade. Next attach the blades to the
motor assembly using the supplied screws.
DO NOT bend the blade arms when
installing the blades.
3.
Attaching the Light kit (Fig. 11)
While holding the light kit assembly under
your fan, snap together the wire connection
plugs. Carefully push all wires back into the
control cup, then install the light kit
assembly onto the control cup plate with 3
screws provided. Be sure to tighten all
screws.
4.
Attaching the Light Bulbs and Glass
Shades (Fig. 12)
Mount the glass shade to the light fixture by
partially unscrewing the thumbscrews on
the glass holder, insert the glass, and then
gently tighten the thumbscrews by hand
evenly to the glass. DO NOT OVER
TIGHTEN. Install 3 x 60W candelabra
bulbs (included).
NOTE:
Federal regulations require all
ceiling fans with light kits manufactured or
imported after January 1, 2009, to limit total
wattage consumed by the light kit to 190W.
Therefore, this fan is equipped with a
wattage limiting device.
A certain amount of wobble may be
considered normal, especially if the fan is
on a downrod long than 12".
6. COMPLETING
THE
INSTALLATION
Fig. 10
Fig. 9
Outlet box
Hanger
bracket
Canopy
Screws
Screws
Screws
Fiber
washers
Screws
Blades
Blade arms
Fig. 11
Fig. 12
Screws
Control
cup plate
Cannon plug
Light kit
assembly
Glass shade
Screws
Bulbs
