standard position
'left' position
1 Tap through
sink
Slacken the brass sink nut. Clinch the
loop in the hose and remove the sink
nut and the loose metal ring. Push the
tap through the hole in the sink.
Fit the rubber ring between the tap
and the sink.
2 Tightening
screws
Set the tap to the desired position
and tighten the screws in the sink nut.
Only if necessary!
A hex head bolt (key width 2 mm)
enables the tap to be twisted if neces-
sary. Slacken the hex head bolt. Viewed
from above turn it clockwise as far as
the stop. Then turn back a few degrees
so that the tap outlet is able to move
freely up and down. Then retighten the
hex head bolt.
1
2
Fitting tap
• N.B. The total length of the boiling water hose is only 50 cm. The tank must
therefore be fitted close to the tap. An extension hose is available but is not
normally required.
B
