Page 2 / 5
Sensor
Turn on the power at fuse or circuit box.
sensor
Fig. 1
Installation Steps
Turn off the power at fuse or circuit box.
Mounting Strap (A)
Outlet Box
Wire Connector (D)
Back Plate
Mounting Screw (B)
Light Head
Fixture Mounting Screw
FRONT
Decorative cover (C)
1. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using
two mounting screws that best fit the outlet box.
2. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Connect the grounding wire from the fixture to the grounding wire from the power source. (usually green / yellow
insulation)
Carefully tuck the wires back into the outlet box.
3. Attach the back plate of the light fixture to the mounting bracket, secure it with the fixture mounting screw.
4. Push the decorative cover firmly into the fixture mounting screw hole on the light fixture.
5. With silicone caulking compound, caulk completely around where the back plate meets the wall surface.
CAUTION: Be sure to caulk completely where the back plate meets the wall surface to prevent water from
seeping into the outlet box.
150105
Adjusting the Sensor Head:
1. Aim sensor head toward desired detection area, maintaining a 5° - 15°
downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with control knob facing
towards the ground.
2. You can move the sensor head up and down to change the coverage area.
(See Fig. 2) Walk through the detection zone at the farthest distance you wish
to detect motion.
Note: Range set too high may increase false triggering.
(See Fig. 2 and Fig. 3 )
Adjustment Sensor Lower For Short Coverage
Adjustment Sensor Higher For Long Coverage
Fig. 2
Fig. 3
