3of3
Figure 1C
DIRECT WIRE OVER AN ELECTRICAL OUTLET BOX
2018 QuoizelInc.
ReleasedDate:2018-04-18
visit us on-line at www.quoizel.com
Step 1C
Cut Cord
-
A. Use wire cutter, cut the cord near the mirror and discard the plug
end. Carefully pull the other end of the cord into the mirror
backplate.
B. Determine the electrical outlet box location behind the mirror.
Leave approximately 8” cord extending to the outlet box location.
C. Go to Step 2C to connect wires.
D. Go to Steps 1A - 3A to mount the mirror to the wall.
REMOVE
Cord
Wire Cutter
8” Min.
Cord
Mirror Back
E
Figure 2C
STEP 2C - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Strip back the wire covering the 3 fixture wires as far as you need to.
This will expose each fixture wire individually. Strip each end of 3
fixture wires.
C. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from mirror
Black wire from
outlet box (or Red)
Black wire
from mirror
Bare, or Green
Ground wire
from outlet box
Ground wire
from mirror
Clean glass with household glass cleaner. Your installation is
completed and ready to use. Enjoy!
QR3703
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4
"
36”
30”
1”
TOUCH SWITCH OPERATIONS
The touch switch has a light to make
it easier to find in the dark.
A) To turn on the light touch the
switch briefly. To turn off touch the
switch briefly again.
B) While the light is on hold your
finger on the switch to dim or
increase the light.
C) When the light is turned off and
turned back on the mirror will
return to the previous dimming
level.
Touch Switch
Mirror
