Quirky AROS, User Manual, Page: 5 / 16

AROS
|
5
DO NOT OPERATE IN FREEZING OUTDOOR CONDITIONS
This air conditioner was not designed for and should not be
used in freezing outdoor conditions.
COOL MODE
Use the Cool mode at Low, Med, or High for cooling. Use the
Temperature Increase / Decrease controls to set the desired
temperature between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off to keep the
room at the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler. Set the thermostat
at a higher number and the indoor air will become warmer.
NOTE: If Aros is off and is then turned on while set to a cool
setting or if turned from a fan setting to a cool setting, it may
take approximately 3 minutes for the compressor to start and
for cooling to begin.
COOLING DESCRIPTIONS
For normal cooling - Select the Cool mode and
High or Med fan with a middle set temperature.
For maximum cooling - Select the Cool mode
and High fan with a lower set temperature.
For quieter and nighttime cooling
- Select the
Cool mode and Low fan with a middle set temperature.
ECO MODE
This mode optimizes the cooling power of your air conditioner,
thereby saving you energy. Once the set point temperature
has been reached, the fan will cycle off to save energy. The fan
will cycle back on periodically to ensure all cooling capacity in
the system is used. This mode is the default mode for the unit.
Each time the unit is powered off, it will restart in Eco mode ON .
The first time the unit is turned on, the settings will be 70° and
Low fan. You can adjust the fan speed and temperature to your
personal comfort.
Eco ON
helps minimize electricity use. It is normal for the fan
to cycle off and then back on in this mode. This on/off cycle
can repeat multiple times. Because the fan will cycle off,
you may notice a variation in room temperature and humidity.
Eco OFF When this mode is not engaged, the fan will run
continuously, and in Cool mode the compressor will cycle on
and off to maintain room temperature.
FAN-ONLY MODE
Use the Fan-only mode at Low, Med, or High fan speed to provide
air circulation and filtering without cooling. Since Fan-only
settings do not provide cooling, a set temperature cannot be
entered. The room temperature will appear in the display.
POWER OUTAGE RECOVERY FEATURE
In the case of a power outage or interruption, the unit will
automatically restart in the settings last used after the power
is restored.