Quipall 2000EPWKIT, Instruction Manual, Page: 7 / 36

7
Attach the high pressure hose to the trigger
gun and machine.
Detach the high pressure hose by pressing
the pawl (A) or button (B)
Push the lance into the trigger gun
When inserted turn it. Caution: Make sure
the lance is properly fixed to the gun
Attach the nozzles. Caution: When
attaching the nozzle, the button (A) on the
nozzle should come out again. Check before
activating the trigger that the nozzle is
properly fixed.
Connecting the water supply pipe
Follow your water supplier’s instructions.
For connection information, see the data
plate/technical specifications
Use a reinforced hose (not supplied) with a
standard connection (ext. diameter:
16mm/int. 12mm, maximum length: 25m).
IMPORTANT!
Only use water without
any impurities. If there is a risk of sand
particles in the inlet water (i.e. from your
own well), an additional filter should be
mounted.
Let the water run through the water hose
before connecting it to the machine to
prevent sand and dirt from penetrating the
machine. Note: Check that the filter is fitted
in the water inlet pipe and that it is not
clogged up.
Connect the water hose to the water supply
by means of the quick connector (inlet
water, max. pressure: 145psi, max.
temperature: 40°C).
Turn on the water.
The trigger gun (1) and lance is affected by
a thrust during operation - therefore always
hold it firmly with both hands.
Plug the power cord into a grounded 120V
outlet, that is on a dedicated circuit. Do not
use extension cord. Press the reset button on
the GFCI plug adapter. This must be done
each time the unit is plugged into an outlet.
Grounded plug/reset button
3.2 Mounting of high pressure hose
3.3 Mounting of lance and nozzle
3.4 Water connection
3.5 Start/stop the machine
A
B
1
2
A
3
12