Page 6
For technical questions, please call 1-888-866-5797.
57460
Instructions
1. Install battery by removing screw(s) and
opening battery compartment. Install
CR2032 battery in correct polarity, close
compartment and replace screw(s).
2. Push the OFF ON button to turn caliper on.
3. To toggle measurement between inches
and millimeters, press in/mm button.
4. With jaws closed, press ZERO
to set readout to 0.00.
5. To measure outside of object,
set the bottom prongs outside
object being measured. Slide the jaws
together until they gently contact the item.
Figure A: Outer Measurement
6. To measure inside of object, set the
top prongs inside object being measured.
Spread prongs apart until they
touch surface of object.
Figure B: Inner Measurement
7. To measure an object’s step, place the
sliding jaw on the upper step of the
workpiece, then spread the prongs apart
until the fixed jaw contacts the lower step.
Note:
Use the ORIGIN button to set
the Caliper to its absolute origin.
Press and hold button for 1.5 seconds
until readout shows 0.00.
Figure C: Step Measurement
8. When finished, press OFF ON
button to turn off Caliper.
