www.quikoitaly.com
GENERAL ADVICE
Install a gate’s safety system that complies with current regulations. Choose short routes for cables and keep power cables separate
from control ones. Install the control card in a waterproof box.
Please refer to current regulations when setting the gear motor’s maximum torque.
We advice you to install an outdoor switch, in compliance with European standards on the issue of safety, to turn the electricity off when
servicing the gate.
Check that each single installed device is efficient and effective.
Affix easily readable signs warning about the presence of a motorized gate
USE
It is absolutely forbidden to use the device for any other purposes. The installed control board (which must have built-in electric friction),
allows to select the following functions:
automatic:
one control impulse will open or close the gate;
semi-automatic:
one control impulse will open or close the gate.
In case of a blackout, manual operation is possible by activating the unlocking device.
Having an automatic and electric power device requires special attention in a few situations:
-
not to touch the device with wet hands and/or wet or bare feet;
-
to turn off electricity before opening the control box and/or actuator;
-
not to pull the lead to pull the plug out;
-
to put the gate in movement only when it is completely visible;
-
to keep out of the gate’s range of action if it is moving. Wait until it has stopped;
-
not to let children or animals play near the gate;
-
not to let children use the remote control or other operating devices;
-
to carry out routine maintenance;
-
in case of failure, to turn off electricity and operate the gate manually only if it is possible and safe. Refrain from touching
the gate and call an authorized technician.
MAINTENANCE
The ERCOLE is a gear motor for long-term use. Nonetheless, their normal operation can be compromised by the conditions of the
gate; therefore, we will list some operations to keep the gate efficient.
Warning:
Non-specialized staff cannot operate the gate during maintenance. You are advised to cut the network power in order to avoid
accidents or shocks. If the power must be on for various inspections, you are advised to check and/or deactivate any possible control
devices (remote controls, keyboards, etc…) except for the devise used by the maintenance operator.
Routine maintenance
Each of the following operations must be done when needed and in all cases at least every 6 months:
Gate
Lubricate the gate’s sliding wheels;
Check the cleanliness and air-tightness of the rack.
Automation System
Check the operation of the safety devices (photo-cells, ribs, torque limiter) using the methods described by the suppliers
Extraordinary Maintenance
If special maintenance is required for mechanical parts, you are advised to send the gear motor out for
repairs to be performed by the technicians at the manufacturer.
Summary of Contents for QK E3000
Page 11: ...www quikoitaly com ...
