QUIK CORP QUIKSPRAY QR400 UTV SYSTEM, Instruction Manual

Page: 6 / 34

QR400 Manual 5

WARNING
PLEASE FOLLOW ALL WARNINGS AS FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY, PERMANENT
INJURY OR DEATH
1. DO NOT start the unit until you have read this manual carefully.
2. DO NOT let any person near the unit while it is operating.
3. DO NOT start motor with pressure lever in the “press position”
4. DO NOT pull the hose out too fast as the reel may run on, causing the hose to become entangled.
5. DO NOT alter the equipment in any manner. If repairs are necessary use only genuine factory repair parts.
6. DO NOT leave the unit running unattended at any time.
7. DO NOT operate the unit if there are any leaks from hoses, fittings ect. Fluids which are under high pressure can
penetrate the skin.
8. DO NOT operate near power lines, as contact could result in electrocution.
9. DO NOT refuel the engine until it has stopped and, if any fuel is spilled, make sure the area is dry before starting
the engine.
Prior to operating your spray system, please read the following
instructions carefully.
1. Check all spray guns are connected and water tight.
2. Ensure the water tank is filled.
3. Ensure there is fuel in the motor (unleaded).
4. Ensure the correct oil level in pump (pump manual).
5. Ensure the correct oil level in motor (motor manual).
6. Ensure the controller 2-way ball valves in the off position.
7. Ensure the pressure lever is in bypass position.
8. Ensure all safety guards and shields are in place.
9. Ensure all nuts, bolts, and screws are in place and tight. 10. Ensure the radio on/off switch in the off position.
11. Make sure that the unit is in an open space (exhaust gas
is poisonous).
12. All maintenance schedules have been completed.
13. Start engine (see engine manual).
14. Adjust engine revs to approximately 2400 rpm or ¾ revs.
PRE-OPERATION CHECKLIST