Rev 1.0
Page 4 of
4
4.4
If only one of the timer LEDs is on and only one of the speed LEDs is on after pressing either button
in sleep mode, the hub is running the motor at the set speed and the timer is in the set delay-off state.
Fig. 6
Front Panel LEDs for Status Reporting
4.5
If all the timer LEDs are on and only one of the speed LEDs is on after pressing either button in sleep mode, the
hub is running the motor continuously at the set speed.
4.6
In normal operation state (in-wall switch has LED on, but no LED blinking), pressing either button on the in-wall
switch will make either timer LED blinking or speed LED blinking, and will enter setting change state. Pressing the
button again will change the setting:
a.
Timer setting will change in a sequence by each pressing: through “1hr -> 2hrs -> 4hrs ->8hrs -> 12hrs
-> Continuous on-> OFF -> 1 hr-> 2hrs -> 4 hrs->8hrs -> 12hrs -> Continuous on-> OFF -> etc.
b.
Speed setting will change in a sequence by each pressing:
1 speed fan: on -> off -> on -> off
2 speed fan: high speed -> low speed -> off -> high speed -> low speed -> off
3 speed fan: high speed -> medium speed -> low speed -> high speed -> medium speed -> low speed;
The corresponding LED will be on in sequence as well.
If there is no button operation within 3 seconds, the setting will be saved and will be in effect.
However, if all the indicators start to blink even after no button operation for 3 seconds, the in-wall switch is not connected to the hub. Please press either
button on the in-wall switch to re-establish connection to the hub.
Notes:
1.
There will always be a timer selection needed in order for the fan to operate.
When the timer status is in “off”, you can still change the speed, but the speed setting is in effect only after a timer setting is selected.
2.
If the corresponding DIP switch of the fan is configured incorrectly, all the indicators on the hub will keep blinking when the hub is powered on. Please
switch off power and re-configure the DIP switch correctly. Then try again.
