l
Run the
debugging ipv6 nd
command in the user view to debug IPv6 neighbors status and
ND messages.
l
Run the
debugging ipv6 packet
[
error
] [
acl
acl-number
] command in the user view to
debug IPv6 packet.
l
Run the
debugging ipv6 pathmtu
command in the user view to debug PMTU.
l
Run the
debugging tcp ipv6
{
event
|
packet
} [
task-id
task id
|
socket-id
socket id
]
command in the user view to debug TCP6.
l
Run the
debugging udp ipv6 packet
[
task-id
task id
|
socket-id
socket id
] command in
the user view to debug UDP6.
----End
5.6 Configuration Examples
This section provides a configuration example of IPv6 addresses.
5.6.1 Example for Setting an IPv6 Address for an Interface
This section provides a configuration example of IPv6 address for an interface.
Networking Requirements
As shown in
, two Switches are connected through Eth 0/0/1. The Eth 0/0/1 interfaces
of Switch A and Switch B correspond to their VLANIF 100 interfaces. You need to set IPv6
global unicast addresses for the VLANIF 100 interfaces and check the Layer 3 interconnection
between them.
The IPv6 global unicast addresses for the interfaces are 3001::1/64 and 3001::2/64.
Figure 5-1
Networking diagram for setting IPv6 addresses
Ethernet 0/0/1
VLANIF 100
3001::1/64
Ethernet 0/0/1
VLANIF 100
3001::2/64
SwitchA
SwitchB
Configuration Roadmap
The configuration roadmap is as follows:
1.
Enable the IPv6 forwarding capability on the Switch.
2.
Set IPv6 global unicast addresses for the interfaces.
Data Preparation
To complete the configuration, you need the following data.
Quidway S2700 Series Ethernet Switches
Configuration Guide - IP Service
5 Basic Configurations of IPv6
Issue 01 (2011-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
70