EtherRain User Guide Rev 1b, August 2017
6
Reset
EtherRain can be reset to the original factory configuration using this procedure.
Reset is only required in cases where a password is forgotten or if the controller needs to have a static IP
address that is out of range of the existing network reset back to DHCP.
To reset to default settings:
1. Unplug the power transformer or disconnect the power plug.
2. Remove the top from the enclosure by removing the four screws located at the bottom of the
enclosure.
3. Locate the two-pin jumper located on the relay board. A blue or black plastic jumper is provided.
4. Install the Jumper block to connect the two jumper pins.
5. Make sure the Ethernet connector remains connected to the network.
6. Re-apply power to the controller for 20 seconds.
7. Remove power by unplugging the transformer or disconnecting the power plug.
8. Remove the jumper, reposition the jumper so it no longer connects the two jumper pins together.
9. Re-install the cover and the screws.
The original configuration of the EtherRain controller is:
1. DHCP ON
2. Default address: 192.168.1.204
3. Default netmask: 255.255.255.0
4. Default password: pw
Once the controller has been reset, it can be configured using the Windows-based EtherRain Admin
configuration software.
Opening the controller voids the warranty, so please be careful!
