QuickLabel Systems pronto! 482, User Manual

Page: 184 / 256

10-16 CS4 Cutter/Stacker Accessory
Error Messages
Specific Error Messages concerning the Stacker with Cutter
Error message Cause Remedy
Cutter jammed Motor current increases too much, cutter returns in the home
position without completion of the cut.
Material too thick Change material
Bracket on the upper blade
collides with safety cover Use safety covers matching the
table width. Re-adjust the
movable side plates.
Table does not move
downwards while stacking Reduce the brake of table
movement as necessary by
turning the screw (1) anti-
clockwise in steps of quarter
turns.
Cutter blocked Cutter cannot reach the home
position within a defined time
after cut start Switch off the printer. Remove
material. Switch on the printer.
Restart print job.
Change material
No cutter function Switch the printer off and then
on. If error recurs call service.
Cutter open Cover of the stacker is not
closed Close cover. Press pause key to
continue the print job.
Box full Table has reached the lower
end position and cannot take
anymore labels Remove stack. Move table
upwards until it stops. Press
pause key to continue the
print job.