QuickLabel Systems pronto! 482, User Manual

Page: 166 / 256

9-14 CU4 Cutter Accessory
1 Tighten the bearing plate (15) with the screws (8) at the profile (7). Keep
the bearing plate in position and push it slightly to the profile (7) during
tightening.
2 Tighten the screw set (4) of the gear-wheel circular blade at the rear of the
printer.
3 Grease the circular blade according to Lubrication on page 9-10.
Adjusting the Circular Blade and the Clock
Wheel
To operate the cutter correctly after cleaning or after changing the blades you
have to adjust the circular blade (1) and the clock wheel (2) to another.
1 Unscrew the cover (4) by loosening the screws (3), (5) and (9, at the rear).
2 Loosen the screw (8) about 5 mm from the profile of the cutter.
3 Turn the axle (7) of the circular blade with a screwdriver for slotted head
screws (slot width 7 mm) so that the inscription (4) of the blade points
downward.
On the axles of the circular blade (1) and the clock wheel (2) you can find
a planar area (A, B). Now or after one or two more full turns of the
circular blade the axles (1, 2) are justified and the areas (A, B) both are
pointing to the rear of the cutter.
Caution: Before mounting the cutter the circular blade has to be
repositioned as described in section Adjusting the Circular Blade and the
Clock Wheel.