QuickJack BL-3500SLX, Setup And Operation Manual

Page: 34 / 72

QuickJack™ Portable Car Jack
34
P/N 5900959 — Rev. L1 — December 2020
5. Put a Vehicle into place.
Do not raise your QuickJack without the weight of a Vehicle
.
6. Position the Lift Blocks in the Receiver Trays for the Vehicle you are going to raise.
Be sure to use the factory-recommended Lifting Points for the Vehicle.
7. Press Up on the Pendant Control for a couple of seconds.
After a few seconds, the QuickJack Frames will start moving up. As this is the first use, it takes a
couple of seconds for the Hydraulic Hoses to fill with fluid.
If the QuickJack Frames do not move, make sure the Power Unit is connected to an appropriate
power source, make sure the Hydraulic Hoses are connected to the Power Unit, and make sure
there is sufficient Hydraulic Fluid in the reservoir. If you find any of these issues, fix them and then
try again. If the Frames still do not move, refer to
Troubleshooting
.
8. Just before the Frames make contact with the Lifting Points on the Vehicle, release
Up
.
The Frames stop moving.
Check the locations where the Lift Blocks will hit the Lifting Points. If necessary, adjust the Lift
Blocks so they are properly positioned (you may need to lower the Vehicle to adjust them).
9. Press
Up
to raise the Frames to just past the First Locking Position, then press
Down
for a
second or two.
⚠
WARNING If one Frame goes up faster than the other with the weight of a Vehicle on it, this is
a safety hazard. Release
Up immediately and then press Down to lower the
Vehicle back down to the ground. Wait a minute and then try again. If the issue
continues, refer to Troubleshooting .
The Lock Bar will lock at the First Locking Position and the Frames will stop moving.
10. With the QuickJack engaged on the First Locking Position, check all Hydraulic Hose connections
for leaks. If you find any, tighten the leaking connection and wipe up the fluid.
If the motor gets hot or sounds irregular, check the Power Unit and all electrical connections.
11. Carefully rock the Vehicle to test its stability.
If the Vehicle seems stable, the QuickJack is ready for normal operation.
If the Vehicle does
not
seem stable, lower it back to the ground and check the positioning of the
Lift Blocks in the Receiver Trays.
12. If everything appears to be working normally, lower the QuickJack Frames back down to the
ground. To do this: press
Up
for a second or two so that the Lock Bars go past the Lock Blocks,
then press Down until the Lock Bars lower past the Lock Blocks.
When the Frames get to the ground, hold Down for another ~5 seconds so that the Hydraulic
Fluid returns to the reservoir.
If there are issues you cannot resolve, stop using the QuickJack, then refer to
Troubleshooting ,
or call QuickJack at (888) 262-3880 or (805) 933-9970 .
Leave the Manual with the Owner/Operator
Make sure to leave the
Setup and Operation Manual
with the owner/operator so that it is available to
everyone who is going to use the QuickJack.