Quickie Quickie S-646, User Instruction Manual & Warranty

Page: 15 / 27

I X . S e t - u p , A d j u s t m e n t & U s e
930477 Rev. A
28
930477 Rev. A
I X . S e t - u p , A d j u s t m e n t & U s e 29
E. SWING-AWAY FOOTRESTS
1. Installation
a) Place swing-away pivot pin (E) into the locat-
ing hole (F) on top of the hanger mount with
the footrest facing outward from frame.
b) Rotate the footrest inward until latch plate
locks (G) into place on locking bolt.
2. Removal
a) To remove footrest, press quick-release lever
(H).
b) Rotate footrest outward and lift.
3. Height Adjustment
a) Loosen both bolts (A) in the hanger frame tube.
b) Reposition footrest height.
c) Re-tighten both bolts (A).
F. ELEVATING LEGREST (OPTIONAL)
1. Installation
To install or remove Elevating Legrest (ELR) see instruc-
tions for Swing-away Footrest installation.
2. Adjustment
a) To raise legrest, lift to desired position. Legrest
will automatically lock in place.
b) To lower legrest, while seated in chair, first lift
slightly then press release lever (B) down and
lower legrest to desired position.
G. REMOTE JOYSTICK INSTALLATION (OPTIONAL)
1. To Connect
a) Line up the small cylindrical connectors with
each other.
b) Push together firmly.
2. To disconnect
Pull back on the retaining ring (A) of the lead
cylindrical connector until it disconnects from the
power cable.
C. CHECK-OUT
Be sure this chair performs to your chosen operational
settings. If it does not, turn the chair off immediately
and reprogram with the Quickie QTronix Programmer. if
you do not own a Quickie QTronix Programmer have
your supplier reprogram your wheelchair as needed. Or,
you can order a Quickie QTronix Programming Pad for
your own use, from your supplier.
NOTE– Repeat this procedure until the chair performs
to your specifications
When properly set-up, this chair will operate
smoothly. Check to see that all components
work properly. If you detect a problem, be sure
to correct it before use.
D. BATTERY REMOVAL
To remove batteries for transport or service:
1. Unlatch both the right and left battery box rear
cover retaining fasteners (A) by flipping back
both latches and rotating one half turn.
2. Lower battery box rear cover (B) until the cover
is fully extended and supported by the cables
(C).
3. Disconnect the battery harness cables.
4. Slide out batteries (D).
5. Remove batteries (D).
Batteries may weigh up to 55 lbs. Care must be
taken to avoid injury when lifting.
E
H
F
G
A
A
C
D
B
A
A
A
B