Quicke Q20, Technical Manual

Page: 21 / 47

2005-09 4:3
Installation
9
0
4
0
0
1
2
1
0
7
a
_
mo
n
t
a
v
la
st
a
re
_
tm.
in
d
d
Installing the loader
B CAUTION: Risk of crushing.
The lock handle is spring-loaded. The lock
handle must be loosened in the parked posi-
tion. Handle the lock handle carefully.
Install LOCK & GO on the left and right bearing boxes.
Install a subframe stop on the left and right base.
Note: The lock handle shall be in locked position if the
loader is laid on the ground.
Lift the loader up onto the subframe. Holes for attaching the
lifting hooks are found on the inside of the tie plates.
Note: Make sure that the lock handle on LOCK & GO is
extended and rests against the lug. When the bearing boxes
passes the mast, the LOCK & GO system will lock the
loader to the subframe. Make sure that the green end of the
lock pin is visible on both the right and left bearing boxes'
inside.
Install LOCK & GO as well as subframe stop (A).
Hole for attachment of lift hooks.
Connect the hoses to the valve, if one is installed, in
accordance with the number markings 1 - 4.
Before installation, depressurise the hydraulic system.
Connect hoses to valve.