16
EN
INSTALLATION AND USE MANUAL QUICK
XR8
- REV01A
XR8
2.0 - Package contains the following parts
• Windlass (top + motoriduttore)
• Contactor unit or reversing contactor unit.
• Handle
• Bolts and screw
• Installation and use manual, Warranty
• Drill template
2.1 - Quick accessories needed, not included in the standard supply
• Chain pipe DX/SX
• Remote brake handwhee
2.2 - Tools needed for installation
• Drill and drill bits: Ø 15 mm (19/32”),
• Hollow mill Ø 250 mm (9” 27/32)
• Hexagonal wrenche: 17 e 19 mm
2.3 - Quick accessories recommended
•
Electrical connection box for motors (EC-Box)
• Inverter
•
windlasses control board (mod. 800)
•
Waterproof hand helds R/C (mod. HRC 1002)
•
Foot switch
• Radio control RRC
• Chain stopper
3 - Introduction
BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST “QUICK
®
” DEALER.
This document contains the instructions that are necessary for boat manufacturers and marine equipment installers to assemble and
commission
the Windlass.
Warning
symbol concerning hazardous situations.
Caution
symbol to avoid direct or indirect damage
to the product.
This manual contains Warning and/or Caution symbols that are important for safety.
Comply with the recommendations provided herein.
3.0 Important notes
F
3.1 Precautions
The Quick® windlasses are designed to weigh the anchor.
• Do not use the equipment for other purposes.
• Quick® shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use of the equi-
pment.
• The windlass is not designed for the loads that might occur in extreme weather conditions (storms).
• Do not power the windlass from places where it can’t be seen operating.
• Always deactivate the windlass when not in use.
• Check that there are no swimmers nearby before dropping anchor.
•
For improved safety we recommend installing at least two anchor windlass controls in case one is accidentally damaged.
2 - Supplied parts
