17
GP2 SERIES GENIUS 1500/2000 - REV001B
EN
WARNING - USAGE
WARNING
WARNING:
stay clear of the chains, ropes and gypsy. Make sure the electric motor is off when windlass is used manually
(even when using the handle to disengage the clutch). In fact people with windlass remote controls (hand-held remote
control or radio-controlled systems) might accidentally operate it.
WARNING:
secure the chain with a device before starting the navigation.
WARNING:
do not operate the windlass by using the electrical power when the handle is inserted in the drum or into
the gypsy cover.
WARNING:
Quick
®
suggests the use of a protection such as a fuse/thermal-magnetic/ hydraulic-magnetic circuit breaker
of suitable power according to the motor chosen, in order to protect it from any overheating or short circuits. The circuit
breaker can be used to cut off power to the windlass control circuit and so avoid accidental activation.
CLUTCH USE
MOD. FF
(see drawing on page 21)
The clutch
F
) provides a link between the gypsy and the main shaft (
A
). The clutch can be released (disengagement) by using the
handle (37) which, when inserted into the gypsy cover (
F
), must be turned counter-clockwise. The clutch will be re-engaged by
turning it clockwise.
MOD. 1500/2000
(see drawing on page 18-19)
The clutch (34) provides a link between the gypsy and the main shaft (28 or 46). The clutch can be released (disengagement)
by using the handle (37) which, when inserted in the bush (49) of the drum or into the gypsy cover (36), must be turned coun-
ter-clockwise. The clutch will be re-engaged by turning it clockwise.
WEIGHING THE ANCHOR
Turn on the engine. Make sure the clutch is engaged and remove the handle. Press the UP button on the control provided. If the
windlass stops and the hydraulic magnetic switch (or thermal cutout) has not tripped, wait a few seconds and try again (avoid
keeping the button pressed). If the hydraulic magnetic switch, has tripped, reset it and wait a few minutes before weighing an-
chor once again. If, after a number of attempts, the windlass is still blocked, we suggest to move the boat to release the anchor.
Check the upward movement of the chain for the last few meters in order to avoid damages to the bow.
CASTING THE ANCHOR
The anchor can be cast by using the electrical control or manually. To operate manually, the clutch must be disengaged allowing
the gypsy to revolve and letting the rope or chain fall into the water. To slow down the chain, the handle must be turned clock-
wise. To cast the anchor by using the electrical power, press the DOWN button on the control provided. In this manner, anchor
casting is under control and the chain and rope unwind evenly. In order to avoid any stress on the windlass -once the boat is
anchored- fasten the chain or secure it in place with a rope.
DRUM USE MOD.1500 D / 2000 D
(see drawing on page 18-19)
WARNING:
before carrying out warping operations, check that the anchor and relative rope or chain are solidly fixed to
a bitt or another strong point on the boat.
For the independent use of the drum (48) release the clutch with the handle (37), (at least 2 turns of the bush anticlockwise).
Remove the handle from the bush (49) on the gypsy, wrap the rope around the drum (at least 3 turns). Activate the windlass
control, keeping the rope under tension during take up. By varying the tension during take up it is possible to modify the rope
winding speed.
WARNING:
during take up maintain a safe distance between hands and windlass drum.
Once take up is complete, screw up the clutch by tightening the gypsy drum clockwise and secure the rope to a bitt or other
strong point on the boat.
Summary of Contents for GP2 Genius 1500 Series
Page 2: ......
