Code 39 Append
This function allows the scanner to append several Code 39 barcode data together before transmitting to host. When
the scanner encounters a Code 39 barcode with append character (ex. Space character), it buffers the data until it
reads a Code 39 barcode which does not have append character. Then the data is transmitted in the order that the
barcodes were read.
Enable Append
Disable Append (Default)
Code 39 Full ASCII
Enable Code 39 Full ASCII
Disable Code 39 Full ASCII (Default)
Message Length
Message length can be set to the maximum value, minimum value. The value is valid between the maximum and the
minimum.
The maximum value and minimum value can be set using Programming command. Please check the programming
command guide for the detail.
Code 39 max length command: 020308. The parameter of this command can be set from min to 48.
Code 39 min length command: 020307. The parameter of this command can be set from 0 to max.
Example: Set the Barcode Message length of the minimum value is 10; the maximum value is 25.
Programming command: Max: 02030825 ; Min: 02030710.
35
Summary of Contents for QU-RT-331
