Monza Deluxe Super Automatic Espresso Machine
6
6
Before using the machine, your water
should be tested for hardness. This is
important to help prolong the life of the
machine and keep it in proper working
order.
If your water is above 3 grains/50 ppm of
hardness then the use of an in tank
softener for reservoir use or a softening
system if you are hooking the machine
to a water line is recommended.
The machine comes with a raised
platform which requires the feet to be
screwed into the base of the platform.
The machine can be operated with or
without the platform, but is required if the
machine is going to be hooked up to a
drain system.
Remove the machine from its packaging
and place on a level surface. Remove
the power cord and cup pedestal from
the water reservoir and grounds drawer.
Rinse the water reservoir out and fill with
softened water and then carefully place
into the machine. (Not dishwasher safe)
Install the power cord into the receptacle
in the back of the machine.
For reservoir use ensure the toggle
switch on the back is in the “TANICA”
position.
Turn on the main power switch on the
back of the machine.
Press the power button on the front
touchpad to turn the machine on.
When the d
isplay reads “Machine
Ready” you are ready to make espresso.
To turn the machine off hold the power
button and then hold the exit button at
the same time until it powers down.
For direct connect installation the use of
a filter system is recomended. The direct
connect kit is set up
with a 1/4” John
Guest quick connection for easy set up.
Unscrew the cap fitting from the back of
the machine labeled as 3 in diagram 4.3.
Place the fiber washer in between the
braided water line and the direct connect
fitting on the back of the machine and
then screw the braided line on with a
wrench. No teflon tape is needed.
Hook the regulator up to your water
supply with 1/4 tubing (not provided) The
regulator has been set prior to shipping
and should not require any adjustment.
Turn the water supply on and verify
there are no leaks.
Flip the toggle switch on the back of the
machine to the “RETE” position and
installation is complete.
If you are using a softening system with
your machine be sure to replace or
recharge the softener as specified by the
manufacturer. Lifespan will vary based
on your waters hardness. Contact your
dealer if you have any questions about
water treatment.
Depending on your water pressure, you
may experience some “chattering” of the
braided line. To adjust the regulator, pull
the adjustment knob out and turn to
adjust, push the knob in when done to
lock setting. The regulator should only
be adjusted while water is running
through it (brewing espresso) Do not
exceed 1 bar of water pressure.
Important:
When using the machine
plumbed in there will be some residual
fresh water that is discharged into the
reservoir so it is necesary to periodically
check and empty the reservoir.
FIRST TIME SET UP
DIRECT CONNECT KIT
