QUICK START INSTRUCTIONS:
Check that the temporary label on top of the charger marked with
the profile setting matches your battery type. If not, see the
reprogramming section.
These chargers work very simply. Once connected to batteries and
plugged into AC power, the LED will flash red for a few seconds,
then turn steady red. When the cycle is 80% complete it will turn
yellow, and finally green when cycle is complete.
If the profile is set to float the battery(s) after complete charge, the
LED will flicker green. If the profile is set to maintain after
complete charge, the cycle will end with a steady green. The LED
may also flicker when it is at the high limit of the charge cycle.
To discontinue charging, unplug AC power.
Look to the Trouble shooting section for any deviations from this.
READ COMPLETE INSTRUCTIONS BEFORE PROCEEDING
