Page: 6
Screen House Mini
instructions
Folding and Unfolding
Details on how to use your product.
Erecting your Screen House
• Remove the screen house from the carry bag and place onto the ground.
• Hold the roof hub in your hand and raise up. The frame will start to unfold and you should have the
black floor on the ground. You can then place the roof hub on the ground.
• IMPORTANT
before proceeding, esnure that the black floor is on the ground and that the frame is not
tangled with any of the fabric.
• Start next to any side and pull the side centre hub towards you using the webbing strap. This will pop
the side out towards you.
• Repeat this with each side and the screen house will stand up, with the roof pointing down.
• To pup the roof, simply push the centre hub up. You can do this by either going inside the screen
house and pushing up, or by pulling the roof up by the loop on the top, or by pushing one of the roof
beams up. The Screen House is now erected, but we always recommend pegging it down.
• Peg each corner of the screen house inside using the pegging eyelets and pegs that are included in
the screen house (you can use your own pegs if you prefer).
• Once all the corners have been pegged, attach the storm straps (if not already attached) to the
screen house via the stainless steel loop in the centre of the sidewall. Peg the other end of the storm
strap into the ground and then tighten the strap.
• DO NOT
over tighten the strap. The strap should be tight enough to hold the sidewall in place, it
should not pull the sidewall towards the ground. If they are over tightened they can lead the roof to
pop down when in use.
Taking your Screen House down
• The screen house should not be taken down in high winds as it could cause damage when the storm
straps and pegs are removed. If you are taking it down in high winds you must take extra care and
always have more than one person present to help secure the screen house once the straps and pegs
have been removed.
• Slacken the storm straps and remove the pegs from the ground, then remove all pegs from the corners
•
• Next pop the roof down, bt pushing on one of the roof poles and the roof will pop down instantly.
• Walk outside of the screen house and push the centre of the sidewall in until it springs in and collapses.
You may find it easier to hold the top left corner with one hand and push the centre in with the other.
• Repeat on every side until the entire screen house has collapsed.
• Once the screen house is laying on the ground, roll the screen house up.
• ENSURE
that the frame is not twisted when doing this as failure to do so could cause damage to the
product.
• Carefully place the screen house into the carry bag.
