SCUBA TECTOR PRO
6
RETUNE FUNCTION
The retune function is designed for ground balance on highly mineralized ground or narrowing the detection field. XPointer
family detectors are powered by Pulse Induction technology which will not produce any false signals in salt water or
mineralized ground. So you can use the retune function to narrow down the detection field and get closer to the target in a
fast way. When the detector locates metal objects, slowly scan toward the object until the response increases to
full/constant alarm. Then, without moving the detector, just press the power button once to mute the alarm and move the
detector forward again until you hear the target, you can repeat the retune process to further narrow the detection field as
needed. The retune function will make the detector lose detecting depth. Return the detector to full detection depth by
simply power off and back on while holding the detector away from metal objects.
DIVE MODE
When you are going to detect under water more than 10 meters, you need to enter the Dive Mode before diving into the
water, otherwise the water pressure will press the buttons.
To enter the DIVE MODE
, when the detector is on, press and hold the Power Button (or Mode button) for 5 seconds
OR
press the DIVE Mode selection button inside the body compartment for 1 second. The detector will make 5 short sounds,
the screen will show “DIVE MODE”, and the white search light will flash every 2 seconds. The detector is in
Standby State
now.
In the Dive Mode, any single click to the Mode button or Power button is useless since the buttons are locked and do not
work. That means you need to make sure the detector is set to the desired settings before switching to the dive mode.
To activate detecting in the DIVE MODE
, you have to turn the device upside down three times until you hear a long and
two short sounds. Now you can search.
To go back to the standby state
, keep the detector pointed upwards for 5 seconds, until you hear a long sound and the
search light will start to flash every 2 seconds again. The standby state is designed for battery saving while the detector is
not used under water.
To exit the dive mode
, press the Mode buttons 3 times. A long and two short sound will be heard, the battery indicator
flashes once in red and goes out, and the screen shows the battery status, alarm mode & sensitivity level for 3 seconds,
then displays “SCUBA TECTOR”.
